品牌：爱蔻

系统：燃油系统

缸内积碳清除剂

产品编号：

企业标准：Q/YKJH 4

仅供4S店使用

 产品性能： 

1、有效清洗燃烧室、活塞、活塞环槽、等部件上的积炭、附着物；

2、快速释放卡死在活塞环槽中的活塞环,恢复活塞环的弹性及运动性；

3、 降低机油的消耗量；降低发动机的工作噪音； 降低有害气体的排放；

4、 均衡气缸压力，提升动力、节省燃油。

使用方法：

1、预热发动机并使其处在温热（而不是炙热）状态；

2、拆下火花塞（或者喷油嘴），切断点火分电器、高压点火圈或者电瓶之间的导线连接；

3、把缸内积碳清除剂直接倒进燃烧室内（分别对其他气缸重复以上动作）、重新拧上火花塞，静置10-20分钟后，再卸下火花塞，用吸收性好的布将气缸口遮盖，以使喷出的脏物不至于落到漆面上，用启动马达启动发动机几秒钟；

4、分别用破布塞紧各气缸的火花塞孔，启动发动马达让破布冲出来，装上火花塞或者（喷油嘴）；

5、启动发动机，以高怠速运行15分钟，以便使剩余的已经软化的积碳能通过排气管排出。

备注：

1、请避免将本产品掉在汽车漆面上；

2、本产品对三元催化器、氧传感器、橡胶制品及密封件无不良影响；

3、使用该产品后无需更换润滑油。

Product performance:

1. Effectively clean carbon deposits and attachments on combustion chamber, piston, piston ring groove and other parts;

2. Quickly release the piston ring stuck in the piston ring groove and restore its elasticity and mobility;

3. Reduce oil consumption; Reduce the working noise of the engine; Reducing the emission of harmful gases;

4. Balance cylinder pressure, improve power and save fuel.

Usage:

1. Preheat the engine and keep it warm (not hot);

2. Remove the spark plug (or nozzle) and cut off the wire connection between the ignition distributor, high voltage ignition coil or battery;

3, pour the carbon removal agent in cylinder directly into the combustion chamber (repeat the action of other cylinder respectively), the screw on the spark plug, let stand for 10 to 20 minutes, then remove the spark plug, the cylinder mouth with good absorbent cloth cover, to make out the dirt not fall on the paint surface, start the motor start the engine for a few seconds;

4. Tighten the spark plug holes of each cylinder with the rag stopper respectively, start the motor to let the rag rush out and install the spark plug or (fuel injection nozzle);

5. Start the engine and run at a high idle speed for 15 minutes so that the remaining softened carbon deposits can be discharged through the exhaust pipe.

Remark:

1. Please avoid dropping this product on the automobile paint;

2. This product has no adverse effect on ternary catalytic converters, oxygen sensors, rubber products and sealing parts;

3. There is no need to replace lubricating oil after using this product.