品牌：施立盾

系统：全车防锈

快干防锈弹性胶（施立盾粒粒胶）

产品编号：S.02.021 700ML

企业标准：Q/YKJH 6

仅供4S店使用

产品性能:

1、保护车底金属与水隔离，避免生锈

2、堵塞部件联接缝隙，紧扣螺丝避免行驶中脱落；

3、隔除车底噪音传播，防止砂石撞击损害；

4、提高车内行驶舒适感，延长车辆使用寿命

使用方法：

1.将车底需喷涂的部件彻底清洁，如有锈迹应铲除、砂光，达到无尘，无水，无油，无蜡迹将不需喷涂的部位（排气管、发动机、水箱、弹簧、空调冷凝器等）进行严密覆盖。

2.充分摇动本品约2分钟，打开灌盖，去除封口，插入本厂专用喷枪，连接0.6-0.8Mpa压缩空气。在距离喷涂表面约25cm处，来回均匀喷涂。

3.为防止流痕和松垂，建议分三次喷涂。在第一次喷涂完成后，对孔洞，裂缝处使用车腻子填封、刮平；待前一次喷涂干燥后（不少于15分钟）再进行喷涂。厚度达到1.5mm以上隔音效果明显。

4.本品未干固前可用汽油清洗

注意事项：

眼睛接触,请立即用大量的清水清洗,并立即就医;

如果误食,不要催吐,立即就医,并出示该物品的盛装容器或标签。

Armored chassis (oily)

properties:

1, protect the car with water metal isolation, avoid rust

2 and plugging parts connected to the aperture, gripping screw avoid driving fall off;

3, the car in addition to the noise propagation, prevent sand crash damage;

4, improve in-car driving comfort, prolong the service life of the vehicle

Usage :

1. To spray parts of the car will thoroughly clean, if have should be razed and rust sanding, to clean, no water, no oil, no wax mark will need not spraying parts (the exhaust, engine, water tank, spring, air conditioner condenser, etc) closely covered. 

2. Fully moved this article about 2 minutes, open the irrigation cover, remove the seal and insert the factory special spray gun, connection-0.6 Mpa compressed air. In the distance spraying the surface of about 25 cm place, spray evenly back and forth.

3. To prevent flow mark and baggy, suggested in three spraying. In the first time after the completion of the spraying of hole, crack in car use, to blow be bored with child fill seal flat; For a time after dry before spraying (not less than 15 minutes) and then spraying. 1.5 mm thickness above sound insulation effect is obvious.

4. This product did not work to solid available before gasoline to clean

Note:

Avoiding Any Eye Contact ,if contact, please immediately with plenty of clean flowing water and seek medical advice immediately;

If swallowed, don't spits, seek medical advice immediately and show this container or label the dress items.